Use your Philips screwdriver to remove the first two screws - the ones that are nearest the back of the PS4 on the far left and right edge. But it’s an extra step that isn’t 100 percent necessary. You don’t have to do this, but it’ll help you access the fan better so that you can issue a more thorough clean. Keep the screws in a safe place and gently remove the back cover by gently lifting it from the back, near the power unit, first. But just note that this will strip the screws. If you can’t get your hands on one of those screwdrivers, you can use a 2mm flathead screwdriver instead. The best way to remove the screws without damage is with a T9 Torx security bit screwdriver. They might be covered by stickers which you can remove with a knife or a flathead screwdriver. You will need to remove the three screws at the top back of the PS4. To prevent any electrical accidents, unplug the PlayStation, remove the cables and store them elsewhere, so they don’t get in your way. T9 Torx security bit screwdriver or 2mm flathead screwdriver.
So only do this if you’re okay with that knowledge. We’ll show you how.īut remember that following these steps will void the warranty since you’ve disassembled your device. Through links on our site, we may earn an affiliate commission.Before you learn how to clean PS4 fans, you need to open up your PlayStation to access the fans. Stealth Optional is supported by its audience. READ MORE: How to fix the most common PS4 issues If that still doesn't work, then you'll need to send your console in for a service, which you can do by going to the fix and replace page on the PlayStation site. This will delete all of the information on the hard drive though, so you'll need to reinstall literally everything including the basic System Software. If that doesn't work, you can try Reinstalling System Software, which is also accessed from safe mode and is option 7. This basically clears some of the clutter from your PS4. You can then choose option 5 to Rebuild Database. The PS4 will now be in safe mode, so you'll have to connect a PS4 controller to it via USB cable. To access safe mode on your PS4 you'll need to turn off the console first, then turn it on by holding the power button until you hear a beep after seven seconds of holding it. SHOP NOW: the very BEST PS4 accessories Safe mode and other fixes If that's the case, then you'll have to access safe mode. If this doesn't work, then you should test out another disc to make sure it's the PS4, and not the disc itself. Use a very soft cloth to do so or you'll risk scratching it and potentially making the issue worse. The first port of call should be to clean the disc itself. There are a few different fixes for this issue, and that's because there can be a few different causes. So, here's how to fix disc read errors on your PS4.
0 kommentar(er)
